Laboratory Incubator - TE034

Cabinet Construction

  • Standard model features powder-coated door, front, and sides. Interior has 304 stainless steel on door liner, top, bottom, back and sides.
  • 2" O.D access port with access port cover and insulation plug located on side wall of the chamber.

Doors

  • Positive magnetic seal, reversible.

Insulation

  • Entire cabinet structure and doors insulated using 2" polyurethane foam.

Shelving

  • 3 stainless steel wire shelves included. Shelves capable of supporting up to 150 lbs of evenly distributed weight.
  • Full height shelf support pilasters, with double oblong holes on 1/2" centers. Pilasters made of stainless steel. Stainless steel shelf clips to be included for each shelf.

Cooling System

  • Top mounted, thermoelectric cooling system.
  • Peltier based technology is solid state, highly efficient, reliable.
  • Semi-Redundant cooling capability.

Electrical Characteristics

  • Unit completely pre-wired at factory, and ready for final connection to a 115/60/1 phase - 15 amp dedicated (recommended) outlet. Unit runs approx. 4 RLA under test conditions.
  • A cord and plug set is included.
  • A sole use circuit is recommended.

Benefits

  • This unit employs our thermoelectric cooling system with heat for unsurpassed temperature uniformity and control with minimal vibration. The cooling components are warranted for 7 years. This size is designed to fit through most commercial doorways or smaller doorways by tilting. This unit uses roughly half the electricity of our compressor driven models and roughly 1/4 the electricity of some of our competitor's models.

Popular options include chart recorder and TraceLock electronic/audit capable locks.

Schema