HT011

The HT series incubators/ovens utilize heat to maintain temperature from as low as 5ºC above ambient conditions to 50ºC. If your set point is within this range, you should look at the models below for maximum efficiency and cost. Running the models below will save you up to 80% in electricity costs vs. a compressor unit from competitors. Additionally, parts are easily replaced since there is no compressor – should you need repairs past the warranty period.

SKU# HT011

Share this Product

About

The HT series was introduced in 2003 as the first commercially manufactured large capacity heated incubator/ovens. The HT series incubators are presently in use by research companies around the world. The advantages of these incubators are described below.

Why Choose the HT Series Incubator/Oven

This superior heated incubator/oven does not employ cooling to maintain temperature. Without cooling components, the HT series is the most efficient and reliable series we sell.

Superior Efficiency

The unit uses roughly 1/4 the electricity of our compressor driven models and roughly 1/8 the electricity of some of our competitor's
models.

Options Available

  • Bench-Top Chamber Capable of Being Stacked
  • Chart Recorder
  • Data Loggers

Widely Proven, Non-Proprietary Controllers

Standard controllers for the HT series are manufactured by Fuji Electric and are ideal for heated incubators. Unlike many proprietary controllers, this controller is commercially available and proven in tens of thousands of installations. Standard functions include: autotuning, fuzzy logic, PID control, programmable alarms, calibration capability, ramp/soak, offset capability, etc. A touchscreen control interface is optional. Other controller manufacturers are also supported (Watlow, Allen Bradley etc.)

Services and Warranties

We offer 24 hour technical support throughout the lifetime of your chamber. In addition to our standard warranties, we also offer extended warranties for cooling components, parts and labor. We also provide qualifications, validations and preventive maintenance services at an additional cost.

Additional information

Cabinet Construction

Standard model features powder-coated, galvanized steel door, front, and sides. Interior has 304 stainless steel on door liner, top, bottom, back and sides.
2" I.D access port with access port cover and insulation plug located on side wall of the chamber.

Racking

Racking available to stack units.

Doors

Positive magnetic seal, reversible.

Insulation

Entire cabinet structure and doors insulated using 2" urethane foam.

Shelving

2 stainless steel wire shelves included. Shelves capable of supporting up to 150 lbs of evenly distributed weight.

Full height shelf support pilasters, with double oblong holes on 1/2" centers. Pilasters made of stainless steel. Four, stainless steel shelf clips to be included for each shelf.

Electrical Characteristics

Unit completely pre-wired at factory, and ready for final connection to a 115/60/1 phase – 15 amp dedicated (recommended) outlet. Chambers equipped with 9ft cord with NEMA 5-15P plug.
A sole use circuit is recommended.

Schema

Close