DB031 Laboratory Incubator

Call for pricing 314-534-3111
To print, click the DB031 Incubator spec sheet (pdf).

CABINET CONSTRUCTION:
• 300 series stainless steel front grill, shroud and doors. 300 series stainless steel exterior ends, top, back, and bottom.
• Interior – 300 series stainless steel interior cabinet side walls, back, door liner, and floor with coved corners. Construction of liner in accordance with NSF standards
• Barrel lock standard for each door. Locks keyed alike.
• Cabinet mounted on a welded, galvanized frame rail, painted for additional corrosion protection.
• Frame rail fitted with 4" diameter casters, (front casters include brakes).

DOORS:
• 300 series stainless steel exterior with 300 series stainless steel interior to match cabinet liner. Doors extend full width of cabinet shell. Door gaskets of one piece construction.
• Lifetime guaranteed adjustable torsion type closure system with aluminum and stainless steel supports. The face of each door fitted with a 12" long recessed handle with sheet metal interlock. Handles are foamed-in-place to insure permanent attachment.

INSULATION:
• Entire cabinet structure and doors insulated using foamed-in-place CFC free polyurethane foam.
SHELVING:
• Adjustable wire shelves (3 per door).
• Shelves capable of supporting up to 250 lbs.

LIGHTING:
• Incandescent interior lighting. Light(s) activated by rocker switch mounted above door(s).

REFRIGERATION SYSTEM:
• Refrigeration system factory balanced using CFC free 134A refrigerant.
• Top mounted condensing unit.
• Factory pre-engineered capillary tube system with oversized condenser and evaporator to reduce product pull down time and to consistently maintain interior cabinet temperature (non-adjustable capillary tube system superior to problematic expansion valve).
• Evaporator - epoxy coated at the time of manufacture to eliminate the potential of corrosion.

ELECTRICAL CHARACTERISTICS:
• Unit completely pre-wired at factory, and ready for final connection to a 115/60/1 phase - 15 amp dedicated outlet. A cord and plug set to be included.
A sole use circuit is required.

Specs
Temperature Range	4°C-60°C
Temperature Control	+0.2°C
Temperature Uniformity	+1.0°C
Ambient Temp. Tolerance	17°C – 30°C
Control Sensitivity	0.1°C
Control Readout	Actual and Set-Point Values
Sensor	NIST-Traceable Platinum RTD
Controller	Microprocessor based PID
Calibration Capability	Yes, actual and set values
Alarm	Audible and visible
Alarm Type	Absolute Hi/Lo in 0.1°C increments
Remote Monitoring	Available
Electrical Requirements	115v, 60 Hz, 10 amps
Interior Cubic Feet	31
Required Clearance	1" all sides
Number of Shelves	3
Cord Length	9'
Crated Weight	300 lbs